This product has been discontinued without a sub item. Please contact customer service for more information.
3M™ Speed Stripper Concentrate 6A is a concentrated product to be diluted and dispensed using only the 3M™ Flow Control System Wall Mount Dispenser or 3M™ Flow Control System PortableDispenser.High performance, 5 minute stripper. Removes sealers and floor finish buildup and finishes hardened by frequent burnishing. No unpleasant odor. 0.5 gallon concentrate bottle yields 10 ready to use gallons.
Features
- Automatic dispensing eliminates measuring and mixing and ensures accurate dilutions
- Superior performance in removing multiple layers of finishes hardened from frequent burnishing
- Five minute dwell time
- Low foaming
- Mild fragrance
- Non-damaging to vinyl
- Non-ammoniated formula strips floors without lengthy downtime. No rinsing or neutralizing needed.
- Remove sealers, floor finish buildup and finishes from resilient floors.
Directions for Use
Refer to ready-to-use SDS for personal protective equipment (PPE)
recommendations.
1. Dispense 3M™ Speed Stripper 6A using the 3M™ Flow Control System Dispenser or dispense 3M™ Speed Stripper 6H using the 3M™ Twist 'n Fill™ Cleaning Chemical Management System.
2. Sweep or dust mop the floor.
3. Properly locate caution signs for wet floor conditions.
4. Liberally apply the diluted stripper solution with a mop (100 sq. ft./gallon), leaving the floor uniformly wet.
Note: Floors become very slippery when stripper softens finish.
5. Allow 5-10 minutes for the stripper to penetrate and soften the finish. Observe the floor and apply additional diluted stripper to areas that may be drying out.
6. Use a low-speed floor machine (175 rpm) with the appropriate 3M stripping pad to thoroughly remove the old finish from the floor.
7. Pick up the soiled solution with a wet vacuum.
8. Flood rinse the floor with clean water and remove with wet vacuum.
9. Check dry floor for residue by wiping with dry hand. If residue is observed, repeat step 8 to ensure full removal.
10. Inspect floor for any remaining finish and repeat steps 4-9 as necessary to remove fully.
11. Mop the floor with a tightly wrung mop of clean water.
12. Let the floor dry completely before applying new finish.